Estimated arrival: 08/25/2020 (If Ordered Today)
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 855.444.6872 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Muscle Cars & Classics always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Best Quality Reproduction Heater Control Valve For 1955 Or 1956 Deluxe Heaters Patterned After Original & NOS Valves This Is The Clip Style Valve If You Have The Capillary Tube Style, You may Remove The Clip From This Valve And Use Your Original Tube In Its Place At some point, you will have to replace your heater core and heater control valve in your 1955 or 1956 Chevy. Some cars used a valve with a capillary tube for the temperature. Early on, Chevy decided this was not necessary and replaced it with a clip style valve. Those with the tube style are not out of luck. Just take off the clip and put your tube in its place...it's that simple!
|Chevrolet||Bel Air||1955 - 1956|
|Chevrolet||Nomad||1955 - 1956|
|Chevrolet||One-Fifty Series||1955 - 1956|
|Chevrolet||Two-Ten Series||1955 - 1956|
Note: HTML is not translated!
Rating: Bad Good